Bonanza fence post (unbeveled) rough from locust wood

The fence posts are cut from straight-grown trunks and left in their sawn state. Since the fence posts are not straightened (trimmed) on the sides, they retain the natural shape of the trunk.

The narrow sides of the fence posts are freed from bark and bast; irregularities are smoothed out. The narrow sides remain rough. Since the width of the fence posts varies naturally, a range measurement is provided.

The growth pattern of the trunk can be seen in the fence post, including embedded branches.

Fence posts made of black locust cannot be nailed - the wood is much too hard for that. If you manage to drive in a nail, the wood may split because it does not give in. Even when using wood screws, you must pre-drill. Stainless steel screws are recommended. Galvanized screws will start to rust outdoors sooner or later, while black locust wood will last for decades.

By choosing black locust wood, you are opting for a wonderful product of nature. This is not an artificial, standardized material. Each piece has its individuality, its liveliness through certain irregularities. These only become defects if they impair functionality.

Measurement tolerances: The specified thickness measurements apply with a tolerance of 10%, but in no case more than 5 mm (at the time of delivery). Due to drying, the thickness measurements can decrease by up to 6%. The specified length is accurate to within 2 cm.

Quality features: Healthy wood; embedded knots are permissible. Construction wood.

Warping and cracks: Wood is alive, as its moisture content - depending on the ambient humidity and climate - affects the dimensions and internal stresses of the wood. Across the grain (radial, tangential), the dimensions can change by up to 6% in practice, while along the grain (axial) the change is very slight.

Larger internal stresses are released as the wood warps and cracks. This must be taken into account. (Our ancestors, whose main material was wood, did this; we tend to forget it today.)

The above is even more true the harder the wood is; black locust wood is the hardest among woods.

How the wood warps and cracks is not concretely predictable. The drier the wood is, the greater the volume shrinkage and the more and larger the cracks generally are. There can be several cracks, or it can concentrate on just one large crack.

On the other hand, the thickness of the wood is crucial. The thicker the wood is, the greater the volume shrinkage that is "compensated" by the cracks. From wood thicknesses of 6 cm, cracks are unavoidable, no matter how carefully it is dried.

The ambient climate can vary greatly. Unprotected or covered outdoors, unheated or heated indoors, sunny side or shady side.

Since we do not know the ambient climate at the place of use, we deliver planed goods air-dried, i.e., with a wood moisture content of about 20%, no more. Then there will be at most slight cracks for thicknesses from 6 cm - in relation to the thickness (see above). In a shady place, the wood will hardly dry out further.

Rapid further drying of the wood in the sun or in a protected place amplifies the stresses in the wood. Then the wood can warp and crack far beyond the inevitable extent.

The end faces of the wood are particularly at risk, as moisture escapes more quickly here. It is therefore advisable to protect and seal the end faces, for example, with a stain.

If you need to store the wood, please do so in a shady, cool place and secured.

Cracks do not impair the strength, load-bearing capacity, and lifespan of the wood.